The Lathe Book: A Complete Guide for the Wood Craftsman

Conover starts with descriptions of typical woodworking lathe construction, features, and advantages of different styles of lathes. There is a lot of discussion of lathe features and accessories. This is a good overview for someone to read BEFORE buying a lathe. There's also a good section on maintenance and repair. I found this very useful since I recently acquired a used lathe without a user manual. Your user manual probably doesn't discuss much overhaul, so it might be quite handy as well.He discusses various tools (gouges, chisels, etc.), how to grind / regrind / sharpen them, and how they're actually used. He describes a lot of basic techniques and types of cuts. I had some trouble following this section because I'm a complete lathe beginner. It took some rereading and experimentation. I think this is because Conover is primarily an expert turner and not so much a how-to writer. However, I think this is better because his craftmanship comes through, and he's actually DONE what he describes -- the techniques are accurate have have been tested.I especially like his directions for building your own chucks, tools, and other accessories. It's too easy to slip into accessory envy (the New Yankee Workshop syndrome), where you feel like you have to buy a small fortune worth of chucks, tools, and accessories. Conover describes a lot of tricks that certainly cost less and probably work better than if you loaded up on toys at the woodworking store. His style here is great because it encourages you to come up with your own creative solutions.Finally, there is a short section with step-by-step instructions for three example projects: a finial, a drawer pull, and a Windsor stool. It might be good to add another book on just projects.